Industrial Bolt does not tighten tightly and keeps slipping. If such a problem occurs, Industrial Bolt Factory can be solved by the following methods:

1. See if the male wire is still slippery, add an aluminum sheet

2. You can flatten the Industrial Bolt. If possible, replace the Industrial Bolt with stainless steel. If it is plastic, it is better to see what material is mainly screwed. For example, if it is wood, add a small wooden strip (toothpick) to the hole. If it is iron

3. Go find some raw material tape, then wrap it around the plastic Industrial Bolt, and then twist it.

4.Industrial Bolt sliding wire can only be changed to Industrial Bolt. If you can’t control it, just cut a little bit of iron in the screw hole and cut it into a long bar. Don’t be too thick and thin (the can can be inside the Wanglaoji). Insert it into the screw hole and screw it. When Industrial Bolt is going to the end, it will slowly twist its own car repair wire. This can be done as long as the force is not too large.

Zhejiang Wego China Stud Supplier is constantly updating its expertise in this area, and we welcome all interested customers to leave us a message.